Phoniex gold AX640A

[ciayung]

Guys do you how i can wire up the control gain because in side the LPL there are four cable Red, yellow green, and black),and the controllor only have three place to soldier the cables, so which one i must put together?
thanks

------------------

[RWAudio]

the two center wires in the phone cord.. (don't remmeber the colors) get soldered to the center pin of the pot...
hope that helps

------------------
Digital Designs 9515b
Memphis 1000D
Pioneer source
MB Quart fronts
ADS power plate (soon Adcom 4404)
RW Audio processors LD4.12MBR
http://www.rwaudio.com
Member of Team Hertz Canada

[ciayung]

thanks, that really help me, but i found another problem do you know how to make the modul to change the crossover point?

------------------


[This message has been edited by ciayung (edited 10-26-2000).]

[RWAudio]

the module to change the x-over freq is just a resistor pack...
the exact resistor values for X freq I don't know at the moment.. I have a PG EQ215X with the 90hz chip in it that I can measure for you if you want...

------------------
Digital Designs 9515b
Memphis 1000D
Pioneer source
MB Quart fronts
ADS power plate (soon Adcom 4404)
RW Audio processors LD4.12MBR
http://www.rwaudio.com
Member of Team Hertz Canada

[ciayung]

Yes please, can u help me to measure so i can make one for my crossover......
Thanks for your help....
cheers


------------------

[RWAudio]

well assuming phoenix uses the same resistor packs in all their stuff...
90hz is 218k ohms
hope that helps
(if you need more info on the resistor pack itself let me know)

------------------
Digital Designs 9515b
Memphis 1000D
Pioneer source
MB Quart fronts
ADS power plate (soon Adcom 4404)
RW Audio processors LD4.12MBR
http://www.rwaudio.com
Member of Team Hertz Canada

[ciayung]

Thanks

------------------