posted
I have a crunch v-600 amp, but it isn't work right now. Apparently the power cable came undone at some point while something in my trunk came against it. Now, the amp won't work. I reconnected the power cable, and when I turn on the car, the 'protect' light blinks on. The power light never comes on. Both fuses are intact. The ground looks intact, and the rca's are connected too. How could I fix this?
Posts: 5 | From: San Antonio | Registered: Jan 2002
| IP: Logged |
posted
Get dads hammer out and beat on it No it's in protection mode = service required. Take it in to where you bought it, or phone around and get a quote on fixing it.
posted
well sounds like the power supply was shorted, if the filter caps are big enough then you're looking at new power suplly and probally pwm as well....
posted
turn the gain all the way down. see if it helps. if it does go on, start turning the gain higher. if you reach to a point where the amp goes into protection mode again, get bigger wires or borrow some from your friend's to test it out. if that doesn't help, like SQstephan said...hammer it! j/k.
Posts: 138 | From: Westminster, CA | Registered: Jan 2002
| IP: Logged |
Printer-friendly view of this topic