posted
I ran a 4 gauge wire down the left side of my suv, rcas on the right w/ the remote, and used the existing wires for the rear 6X9 speakers to go to the hi-input of the second amp ((the rca's go to the sub's amp)),then I ran another set of wires to the speaker terminals of the amp. Everything works and has power. The problem is when the head unit its on with no volume or little volume ((so you can here whats around you)) you can here a buzzing in the two 6X9's. Whats the problem??
Posts: 13 | From: NJ | Registered: Apr 2003
| IP: Logged |
posted
I would guess it may be bec ause the existing wires that you used to run to the "high-Input" may be running too close to a power wire, and are picking up radiated noise , because they are not shielded. Try following the high level input wires and find out if moving them makes a difference. Check your grounds, and even battery fluid levels (if it's a lead acid type with caps on the cells). make sure you're using an appropriate power and ground wire, you may also want to ADD a small ground wire(same guage you're using for power) from the battery ground to the body of the car, under the hood.
-------------------- E.C. Wuz here Posts: 1057 | From: Vancouver, British Columbia, Canada 'eh | Registered: May 1999
| IP: Logged |
Printer-friendly view of this topic