posted
I need a question to be answered if you are or have competed with a trailblazer. How do you build your box to get away with it not being a wall, and without it going past the rear doors. I have a 7.5' cubic box ported and i could remake it to get it below the rear most windows but there's like no way to get it below the lowest most point of the front windows, because of how the car slants to the front. I measured it and like the tallest the box could be would be like 14" that big enough for 2 10"s. I have 4 12"s that require 7.5 cubic ft and i would like to compete in street c without a wall. An info will help thanks
Posts: 10 | From: ohio | Registered: May 2009
| IP: Logged |
posted
Pete pretty much summed it. A 4 12 box should fit nicely in the cargo area of a trailblazer. Explorers have a max height of about 14.5-15 inches dependending on how the vehicle is prepped.If you have close to 30 inches of depth I dont see it being a problem.
-------------------- "TECMO BOWL CHAMPION" Posts: 1364 | From: The Recession | Registered: Dec 2007
| IP: Logged |
posted
i was a bit off on the measurements they are actually 46 wide 13 high 28 deep and i need a 12 in. wide port to have 40hz. that takes the box vol. down to 5.126 and i really need 7.5 cubes.
Posts: 10 | From: ohio | Registered: May 2009
| IP: Logged |
posted
That can work you may need to use aeroports instead of a traditional square port. And depending on the subs your using you can get by with about 6 cubes.
-------------------- "TECMO BOWL CHAMPION" Posts: 1364 | From: The Recession | Registered: Dec 2007
| IP: Logged |
Printer-friendly view of this topic