posted
Im trying to run a couple 6.5 kicker components in my car, what kind of amp should I be using a 2-channel, 4-channel or what? thanks
Posts: 209 | From: OH | Registered: Nov 2003
| IP: Logged |
posted
You can use a 2 channel to run them because of the supplied crossover that works fine or:
You can use a 4 channel bridged to 2 channel to optimize the power available out of most marketed full range amplifies I'm familiar with (assuming your component set is 4 ohm nom so you can bridge it at 4 ohm to the 4 channel to get essentially 2 channels @ 2 ohms) or:
You can use a 4 channel with an active crossover before the amplifier to bi-amp the components.. my personal favorite....
Depends on what you want to do with it? Maybe more of an answer than you were looking for...
posted
ok, thanks for the help, I really appreciate it. So if im running 2 components a 2 channel would work fine then? Also how would I wire up 2 components on each door?
Posts: 209 | From: OH | Registered: Nov 2003
| IP: Logged |
Printer-friendly view of this topic