posted
but dont know how to, since the alarm was install by the first owner. i try purchasing the manual but the seller says he dont have it.
Posts: 2 | From: phil | Registered: Apr 2009
| IP: Logged |
posted
hello Daemon! try this, is from Maat GFM 7500, see if it works.
"Learning Transmitter CODES In case of the remote Transmitter is get lost, stolen, or you need an additional new remote Transmitter, it is essential to learn the CODE between new remote Transmitter and System before use it. It is allowed to learn up to 4 different remote Transmitter. Anytime a new code is entered, it will erase automatically the memories of all previous coding Transmitters. - Entering Learning mode 1) Turn the Ignition ON 2) To flip Valet/Program switch ON/OFF 8 times within 10 seconds and leave it at “OFF” position. You will hear a short siren chirps with LED flashes slowly indicating that the system is ready to learn new transmitter codes within next 15 seconds. - Learning Transmitters To learn Transmitter code: - Press Button #1 (ALARM ON) on the first transmitter, Siren will chirp once to confirm that the 1st Transmitter code is entered. - Press Button #1 (ALARM ON) on the 2nd transmitter, siren will also chirp once to confirm that the 2nd Transmitter is learned, … , siren chirps 2 times to confirm that the 4th Transmitter is learned. - Exiting Learning mode There are three ways to exit the Learning mode: 1) Turn the ignition key “OFF” – siren will make 2 chirps. 2) Do nothing but wait until 20 seconds (When learning less than 4 Transmitters) – siren will make 2 chirps. 3) After learning the 4th Transmitter, siren chirps 2 times, then it will exit Learning mode automatically. After either of above managements, the system will automatically exit the Transmitter Learning program mode and LED will turn OFF as well."
Posts: 2 | From: ROMÂNIA | Registered: Apr 2009
| IP: Logged |
Printer-friendly view of this topic