posted
My shock sensor has a red, black, and a blue wire coming out of it and going to the brain. The green wire comes out and then right back into the sensor. How would I connect the 508D wires to those wires? Also, on which wire would the toggle go on and where on that wire? I mostly would like to use the 508 at night when my truck is just sitting in the yard.
Posts: 5 | From: Massachusetts | Registered: Jul 2007
| IP: Logged |
posted
Thank you for your reply. I'm a little confused on the blue to green wire on the shock sensor harness non loop. If you could explain that part, it would be greatly appreciated. Thanks again.
Posts: 5 | From: Massachusetts | Registered: Jul 2007
| IP: Logged |
posted
In the old days the black, red, blue and green were seperate.
Now they loop the green to blue at the shock sensor. On the other end of the harness there is a green that goes to nothing. That is the wire you want to connect to the blue of the 508D.
-------------------- You are only as good as your worst install.
posted
So the blue from the 508d goes to a green at the brain. Do I connect the 508d green to the sensor green and do I leave the green looped in the sensor?
Posts: 5 | From: Massachusetts | Registered: Jul 2007
| IP: Logged |
Printer-friendly view of this topic