Hi, I'm kinda new on this forum but, I've been following it for a couple days. I hope to learn alot from all of you and maybe share some of my knowledge.
Anyway, I'm looking for the alarm wires (including the remote start wires) for a 1997 Toyota Camry. Plus any tips or tricks to make the installation a little more unbeatable would be appreciated.
that web site should show you all the wire codes. sorry no tips though..
No disrespect to Bulldog, but I would never tap a wire into the fuse panel on a customers car. I will post the real deal on this car Tuesday when I get back to work. I can tell you already that the parking lights wire can probably be found in a connector just above the fuse panel. The door lock type is probably "Negative Pulse". I know there are some special notes on the child safety locks also.
------------------ David McLean Team Quadzilla http://www.teamquadzilla.com
posted
CONSTANT 12 VOLTS(+).........WHITE OR WHITE/RED IN IGNITION HARNESS
IGNITION 12 VOLTS(+).........BLACK/ORANGE IN IGNITION HARNESS
STARTER WIRE(+)..............BLACK/WHITE IN IGNITION HARNESS
DOME LIGHTS(-)...............RED/WHITE AT 7 PIN CONN. AT FUSE BOX
PARKING LIGHTS(+)............GREEN IN PLUG AT FUSE BOX
DOOR LOCK(-).................LIGHT-GREEN DOOR UNLOCK(-)...............DARK GREEN BLUE PLUG IN DRIVERS KICK *CHILD SAFETY DOOR UNLOCK WIRE...... BLUE/BLACK
The following link will take you to alarmteks website. If you go down to the bottom under the heading "relay center" and in the left hand side there is a little white window. Scroll down in the window til you come to child safety locks. A diagram will pop up to the right of that window. The diodes that they speak of are either a 1n4004 or a 1n4001. You can use either, and can be purchased at radio shack or active electronics, or even a shop might sell them to you. http://members.tripod.com/~carprotector/WIRES.html
posted
CONSTANT 12 VOLTS(+) WHITE OR WHITE/RED @IGNITION HARNESS IGNITION 12 VOLTS(+)BLACK/RED @IGNITION HARNESS STARTER WIRE RED @IGNITION HARNESS DOME LIGHTS(-) RED/WHITE @ 7 PIN WHITE CONN. ON TOP OF FUSE BOX TRUNK PIN SWITCH RED/YELLOW (-) AT LIGHT IN TRUNK PARKING LIGHTS GREEN/BLACK (+) 13 PIN WHITE CONNECTOR @ FUSE BOX POWER LOCK LIGHT GREEN*** POWER UNLOCK DARK GREEN*** CHILD SAFETY BLUE/RED (-*** ***ALL WIRES FOUND @ 20 PIN WHITE CONNECTOR IN DRIVER KICK PANEL. LOCK AND UNLOCK WIRES ARE NEGATIVE PULSE THE CHILD SAFETY WIRE NEED TO RECEIVE A GROUND AT THE SAME TIME AS THE UNLOCK WIRE. JUST TAP OFF THE UNLOCK WIRE AND DIODE ISOLATE THE CIRCUIT. OEM HORN GREEN/BLACK (-) STEERING COLUMN HARNESS OEM ALARM ARM BLUE/WHITE (-)** OEM ALARM DISARM RED/GREEN (-)** IF EQUIPPED. YOU CAN ACTUALLY USE YOUR ALARM TO ARM AND DISARM THE FACTORY ALARM. GIVING YOU 2 LAYERS OF PROTECTION TACH SIGNAL BLACK/ORANGE @ECM (ENGINE CONTROL MODULE) LOCATED BEHING GLOVE BOX IGN #2 BLACK/YELLOW @ IGN. HARNESS ACCESSORY BLUE/RED @ IGN HARNESS NEUTRAL SAFETY NOT GROUNDING TYPE - OEM SWITCH OPENS STARTER CIRCUIT BRAKE LIGHT GREEN/WHITE (+) @ SWITCH ABOVE BRAKE PEDAL REVERSE LIGHT RED/BLACK (+) @ 13 PIN WHITE CONNECTOR IN PASS KICK PANEL
PLEASE TEST ALL WIRES BEFORE CONNECTION. I WILL NOT BE RESPONSIBLE FOR USE OF THIS INFORMATION.
------------------ David McLean Team Quadzilla http://www.teamquadzilla.com
Printer-friendly view of this topic