posted
I just recently ordered two Alpine MRD-M500 and a MRV-F540 amps. I'm also going to put a cap to each M500. What gauge wire should I use for power and ground? Also would it be ok to have my ground go to a powersplit and then to each amp and cap? Or is it a lot better to have each component to have it's own ground?
Posts: 9 | From: Ca | Registered: Jun 2002
| IP: Logged |
posted
i had good luck going both ways, using a common ground and doing seperate. make sure you have big enough ground to accomodate for all the stuff, like 2 4 guage should combine into 2 guage and such. later shane
Posts: 8960 | From: over yonder | Registered: May 2001
| IP: Logged |
Printer-friendly view of this topic