posted
I have A clarion 775VD radio.I install A camera for the reverse video it was working fine, all of sudden it stop working. I check the reverse wire leading to the radio from camera, it have power on it when i put the car in reverse I check all the wire from the camera to the radio, im trying to find out is it the camera or the reverse wire on the radio. How can I test it to find out
Posts: 10 | From: brooklyn ,n.y. | Registered: Jan 2008
| IP: Logged |
posted
All the reverse wire is doing is taking an input signal and when it sees this signal and switches to the av input which is the backup camera is hocked up to. Check the wire from the camera to the radio and make sure that you did not screw into the wire or that it is not pinched. If the wire is not frayed at all then, switch over to the av1 or av2 source on the head unit. (Depending on the inputs on the rear of the clarion. If it has a camera input then you should have a source on the unit that says camera. If you have this then click camera) once you select the source and you still don’t get any video input from the camera then the backup camera is bad. Even if you didn't connect the reverse wire at all the the camera would work.
Printer-friendly view of this topic