posted
Hi the back of my box radles so bad that enless i put all my box presure on it it wont stop with the noise. Is there any special things i should do like Bracing seal it better L brackets. Please help. THNAKS and hope to get this fixed.
The box is for 2 12" dds run by 2 d300hc amps. It is all 3/4" mdf.
------------------
Posts: 933 | From: Tinley Park, IL | Registered: Aug 1999
| IP: Logged |
posted
Put another back panel on it...another 3/4 inch piece of MDF. Just add it on top of the other piece to reinforce it...make sure you tighten these two together so it won't make it worse...it you want, put a piece of sound deadener inbetween them. JMO.
------------------ <Viper>
Posts: 84 | From: Hagerstown, IN USA | Registered: Jun 1999
| IP: Logged |
posted
Putting in braces internally will make the box smaller on the inside altering your sound. Add another layer on all sides longer than 12" or so, or all around if you have the room. It can't hurt. I've even gone as far as making some of the panels out of 1" mdf.
------------------ inno73@hotmail.com
Posts: 490 | From: Fort Frances, Ontario, Canada | Registered: May 1999
| IP: Logged |
posted
Take out the subs and fiberglass the inside oif the box everywhere. This will not onily give you a much stronger box but also give you an absolute air tight seal.
------------------ 4 DD 9515-2's 2 VLX-400's And a big ported box!!
Posts: 261 | From: School - Drexel University | Registered: Jun 1999
| IP: Logged |
Printer-friendly view of this topic