posted
They told me to run 3" ports for my typeR's, and now there is loads of port noise when I open up the hatch to listen to the subs. I guess I lost a little spl with these tiny ports to. Shoulda done 4" . Any other way to get rid of port noise beside flaring the ports? They are really rounded out on the edges.
-------------------- Infiniti Qx4: Pioneer P930 H/U, Epic150, MTX8100d, 2 Alpine TypeR 12 SVC's with 1.28cuft tuned to 31hz, JL XR6.5 components (JL 300/4)/VR6 Coaxials (Other half of 300/4) F/R, 1 Farad Stinger HPM Cap, 2 Optima Red-Tops (Soon to be 3), 0/1 Gauge Stinger Wire, All Stinger HPM Fuses and Fuseholders, Cold Air Intake, HKSuv Sport Exhaust, Ignition System
148db's at 45hz... Posts: 239 | From: Mobile, Alabama | Registered: Mar 2001
| IP: Logged |
posted
~2 inches... That should be adequate since you are supposed to do atleast half the diameter right? I could always cut off about an inch off the end of the port; it would only raise my tuning up 1 hz.
-------------------- Infiniti Qx4: Pioneer P930 H/U, Epic150, MTX8100d, 2 Alpine TypeR 12 SVC's with 1.28cuft tuned to 31hz, JL XR6.5 components (JL 300/4)/VR6 Coaxials (Other half of 300/4) F/R, 1 Farad Stinger HPM Cap, 2 Optima Red-Tops (Soon to be 3), 0/1 Gauge Stinger Wire, All Stinger HPM Fuses and Fuseholders, Cold Air Intake, HKSuv Sport Exhaust, Ignition System
148db's at 45hz... Posts: 239 | From: Mobile, Alabama | Registered: Mar 2001
| IP: Logged |
posted
for port area, shoot for around 50 percent of your sub's surface area.... and the minimum distance behind the port i would do is 4"... no matter how small of port it is..
Posts: 1854 | From: freezing in FAIRBANKS ALASKA | Registered: Aug 2000
| IP: Logged |
posted
I guess there is no way to redo the ports since a 4 or greater inch port would be over 20 inches long, and I don't have enough room to clear that. How big do they make flex port?
-------------------- Infiniti Qx4: Pioneer P930 H/U, Epic150, MTX8100d, 2 Alpine TypeR 12 SVC's with 1.28cuft tuned to 31hz, JL XR6.5 components (JL 300/4)/VR6 Coaxials (Other half of 300/4) F/R, 1 Farad Stinger HPM Cap, 2 Optima Red-Tops (Soon to be 3), 0/1 Gauge Stinger Wire, All Stinger HPM Fuses and Fuseholders, Cold Air Intake, HKSuv Sport Exhaust, Ignition System
148db's at 45hz... Posts: 239 | From: Mobile, Alabama | Registered: Mar 2001
| IP: Logged |
Printer-friendly view of this topic